Quick Answer

The right tool is the one matched to the machine, the material and the job. Yes — hybrid/transitional pads (copper bond, ceramic bond) are the bridge between metal-bonded matrix abrading and resin-bonded matrix burnishing. They strip the coarse metal scratch marks and prepare the surface so resin pads can burnish to mirror finish.

For machine-matched tooling, browse our Diamond Trapezoid Grinding Disc (JOY-TP-R3) for Floo... range.

Why the Bridge Is Needed

How the tool works.

The transitional stage sits in between: it uses a softer bond (copper or ceramic) with intermediate grit stages (50–400#) that strip metal scratch marks while refining the surface for resin.

Getting the spec right avoids a wasted order.

When to Use Which

What to check before buying.

Our Copper Bond Hybrid Resin Pads work as the aggressive transitional stage, and Ceramic Bond Transitional Pads refine before resin.

• After metal-bonded matrix 30–200# — switch to copper bond transitional pads to blend the surface.
• Before resin-bonded matrix 800#+ — a ceramic bond transitional pass leaves the fine scratch mark pattern resin can burnish out.
• Skip them? — only on soft or already-even floors; on standard concrete you'll see the difference in the final mirror finish.

Tooling that fits and matches the bond runs noticeably better.

About Typical Sequence

Key selection points.

Fit is the first filter - the rest is performance.

Frequently Asked Questions

Q: Am I able to go straight from metal bond to resin bond?

A: In short, Technically yes, but the resin pads will struggle with deep metal scratch marks and the finish will be hazy. Transitional pads save time overall.

Q: What grit should my transitional pads be?

A: The practical answer is, Start around 50–100# copper bond to strip metal scratch marks, then 200–400# ceramic bond to refine. Match the sequence to your metal-bonded matrix finish grit stage.

Q: Is hybrid pads more expensive per m²?

A: For most jobs, They add one product to the sequence, but they reduce resin pad wear and rework, so the per-m² cost is in most cases lower overall.

Looking for the right tool? Check our Single Rhombus Segment Diamond Trapezoid Grinding Di.... Looking for the right tool? Check our Double Rhombus Segment Diamond Trapezoid Grinding Disc.

Conclusion

Confirm the fit, match the bond to the material, and the tool performs as rated. JOY TECH supplies copper and ceramic bond transitional pads for every equipment type.